Yamaha F300UCB2 300HP Outboard – 30in Shaft, V6
$15,273
☆☆☆☆☆ (0)
No fuel smell, Tohatsu MFS25DETS carries 25 horsepower. A 15-inch shaft rounds out the rigging. Well matched to small aluminum boats and light jon boats. Anglers rely on it for predictable starts, trip after trip. - 25 horsepower, ready to run - Shaft length 15 inches - Straightforward to service a
2820.00 USD
In stock
2820.00 USD
In stock
Sluggish holeshots vanish instantly when the 500cc Tohatsu MFS25DETS hits the water on your low-profile fiberglass skiff. The pressurized Battery-Less EFI system meters gas precisely to deliver crisp acceleration through winding backwater channels. Verifying your exact transom geometry ensures this 15 inch short shaft power tilt outboard fits correctly without creating excessive hydrodynamic drag.
Eliminate severe hull plowing during aggressive acceleration by leveraging the factory power tilt system as a direct mechanical solution. You tuck the 62 kg engine inward from the console switch to push the bow down fast and optimize running attitudes. Tohatsu engineers cast the midsection using impact-deflecting marine aluminum. This thick-wall metal prevents catastrophic structural fatigue when repowering small fiberglass skiffs for shallow water operation.
Key Features of Tohatsu MFS25DETS
- Battery-Less EFI: Atomizes fuel perfectly using internal magnetic power, guaranteeing reliable cold-weather starts if your primary starting battery fails.
- 15-Inch Short Shaft: Matches standard low transoms exactly, preventing excessive drag from a deep gearcase and increasing top-end speeds drastically.
- Hydraulic Power Tilt: Lifts the gearcase completely clear of mud flats at the push of a button, preventing catastrophic propeller strikes.
- Remote Steering Bracketry: Accepts standard mechanical cables directly from your forward helm, integrating flawlessly for precise directional control.
- 17-Amp Charging Alternator: Outputs constant electrical current underway, keeping deep cycle batteries charged for heavy-duty livewell pumps and aerators.
- 500cc Inline-Three Block: Produces massive low-end torque internally, lifting heavily loaded 12-foot rigid dinghies onto plane much faster.
- 2.17:1 Gearcase Ratio: Multiplies engine torque effectively, translating the 500cc displacement into relentless pushing force for loaded hunting skiffs.
- Low-Copper Marine Alloy: Blocks severe galvanic decay physically, protecting the powerhead block across decades of daily saltwater exposure.
- Through-Prop Exhaust: Channels toxic combustion gases directly underwater, keeping the aft deck completely clear of choking smoke.
- Clean Four-Stroke Combustion: Burns fuel highly efficiently without oil mixing, easily meeting strict local waterway emissions regulations and EPA standards.
Why Choose Tohatsu MFS25DETS
Choosing this specific engine limits installation entirely to 15-inch tall transoms rigged with forward steering wheels and throttle boxes. You cannot bolt this onto a tiller-steered skiff. Correcting helm geometry is a key step when finding a reliable short shaft remote outboard replacement.
- Measure the vertical distance from your top transom edge to the keel bottom.
- Install corresponding mechanical control cables sized exactly for your specific boat length.
- Keep local lakes clean by running highly regulated four-stroke engine configurations.
Ideal Application and Vessel Fitment
Engineered for low-profile fiberglass micro-skiffs, classic aluminum bass trackers, and lightweight sport boats equipped with forward consoles, this 500cc block provides oversized displacement torque. Because the shaft length perfectly matches standard transoms, the gearcase generates minimal hydrodynamic drag, maximizing top-end speed on ultra-light hulls. By utilizing the factory power tilt, operators navigating a shallow water remote steer outboard can quickly lift the propeller over oyster bars without leaving the steering wheel.
Warranty, Support and Maintenance
Authorized recreational operation receives a 5-Year Limited Warranty alongside exceptional factory support. Registered commercial applications fall under a strict 1-Year Limited Warranty with zero corrosion coverage applied to the block. Scheduled maintenance requires replacing gearcase lubricants and changing oil filters at manual-specified intervals. Always save all physical service records. Your engine serial number acts as the only way to source exact genuine replacement parts. Mulmotor provides product-information support before purchase and assistance with order-related questions.
| SKU | WC-14646 |
|---|---|
| Category | Outboard Motors |
| Shipping | Included in the price, worldwide Ships in 2–5 days, then 15–21 days in transit |
No reviews yet.
Sign in or create an account to rate this product and share your experience.