Move main-loop HVAC water with Bell & Gossett Series e-80 2 x 2 x 9.5C, a vertical in-line pump listed with a 5 HP motor and nominal 9.5-inch impeller. The 2-inch suction and discharge connections suit commercial chilled-water systems, while the large impeller and low-velocity design target high-volume circulation. The supplied listing identifies 1750 RPM, but the official reference for this configuration indicates a different speed, so verify the motor and curve before purchase.

The in-line centrifugal arrangement uses a 2-inch suction, 2-inch discharge, stainless-steel shaft sleeve, and C-size volute. Flow, head, pressure, voltage, phase, amp draw, dimensions, and weight were not provided. Because the supplied speed information conflicts with the manufacturer reference, confirm the motor nameplate, pump curve, pipe layout, and available vertical clearance before installation.

Key Features & Benefits

- 5 HP Motor: Supports main-loop HVAC and industrial chilled-water circulation.
- 2-Inch Suction: Provides the listed inlet size for compatible commercial piping.
- 2-Inch Discharge: Defines the outlet connection for system layout checks.
- 9.5-Inch Nominal Impeller: Identifies the C-size rotating assembly for equipment comparison.
- Stainless-Steel Shaft Sleeve: Provides the specified shaft-sleeve material for pump service.
- Vertical In-Line Design: Fits systems arranged around a vertical piping run.
- Speed Verification Required: Helps prevent a motor and pump-curve mismatch before installation.
- Low-Velocity Port Design: Suits high-volume circulation where connection restriction must be reviewed.

Why Choose Bell & Gossett Series e-80 2 x 2 x 9.5C

The e-80 2 x 2 x 9.5C is aimed at commercial main-loop service, but its exact motor speed and operating curve must be confirmed before selection.

- Build: Vertical in-line construction, C-size volute, large impeller, and stainless-steel shaft sleeve define the supplied arrangement.
- Value: Correct speed and curve verification can prevent excess flow, poor system balance, and commissioning problems.
- Audience: Intended for commercial HVAC contractors, chilled-water technicians, facility engineers, and industrial maintenance teams.

Applications & Use Cases

Use Bell & Gossett Series e-80 2 x 2 x 9.5C for main-loop HVAC, industrial chilled water, and compatible high-volume circulation. The supplied data identifies 2-inch suction and discharge connections but does not provide dimensions, unit weight, base details, or port reach. Verify speed, mounting clearance, pipe support, and service access before installation.

Warranty & Support

- Warranty Terms Require Confirmation: Verify duration, coverage, registration, exclusions, and authorized service requirements with the seller.
- Confirm the 2 x 2 x 9.5C configuration, 5 HP motor, actual RPM, shaft sleeve, and electrical data before ordering.

Inspect the suction and discharge piping, verify motor speed and rotation, prime the system, and purge trapped air before startup. Monitor flow, pressure, vibration, temperature, and leakage during commissioning. Purchase the Bell & Gossett Series e-80 2 x 2 x 9.5C vertical in-line HVAC pump through Mulmotor.com for authentic equipment, applicable warranty support, and pump assistance.