With a 20 HP TEFC motor at 3525 RPM, the Bell & Gossett e-1510 1.5BC TEFC is a base-mounted end suction pump with 2.5-inch suction and 1.5-inch discharge connections. Its listed IP55 protection rating is a motor-configuration detail for evaluating high-head process-pumping installations and environmental requirements.

High-speed selection requires project-specific hydraulic review. The 1.5BC casing, 20 HP drive, and two-pole motor do not establish a duty point by themselves. Compare required flow, head, suction conditions, fluid properties, and piping resistance with the applicable e-1510 curve. Confirm that the motor enclosure and documented pressure limits match the final installation conditions.

Key Specifications of the Bell & Gossett e-1510 1.5BC End Suction Pump

- The 1.5BC casing provides 2.5-inch suction and 1.5-inch discharge connections for matching process-piping arrangements.
- A 20 HP motor establishes the listed drive capacity for the selected high-head process-pumping configuration.
- The 3525 RPM two-pole motor speed requires confirmation against the approved hydraulic curve and motor selection.
- Totally enclosed fan cooled construction identifies the TEFC motor enclosure specified for this base-mounted pump assembly.
- An IP55 protection rating is listed for the motor configuration and should match environmental project requirements.
- High-head process pumping is the stated application context for evaluating this 20 HP base-mounted configuration.

Hydraulic Performance and Application

This Bell & Gossett end suction pump is identified for harsh-environment and high-head process-pumping applications. Its 1.5BC casing, 20 HP motor, and 3525 RPM speed are selection inputs, not a confirmed operating point. Use the applicable e-1510 curve to establish required flow, calculated head, suction conditions, fluid requirements, and motor load before equipment selection.

Installation and System Requirements

Confirm compatible three-phase electrical service, motor rotation, suction arrangement, piping layout, and the approved pump curve before installation. Verify the 2.5-inch suction and 1.5-inch discharge connections against the project pipework. Provide independent piping support to prevent casing strain. Follow official e-1510 instructions for base mounting, coupling alignment, motor connection, and startup checks.

Why Choose the Bell & Gossett e-1510 1.5BC TEFC

This configuration pairs a 1.5BC base-mounted casing with a 20 HP, 3525 RPM TEFC motor and IP55 protection rating. Its defined 2.5-inch suction and 1.5-inch discharge connections help verify pipe fitment. Buyers can compare these motor and casing details with the environmental conditions, system curve, pressure requirements, and project duty before ordering.

Warranty and Support

Bell & Gossett commercial pumps carry a 1-Year Limited Warranty against defects in materials and workmanship. Coverage begins at installation and ends no later than eighteen months from shipment, whichever occurs first. Seals, gaskets, elastomers, coatings, and other wear parts are excluded unless sales documentation states otherwise. Mulmotor provides product-information support before purchase and assistance with order-related questions.

Before Ordering the Bell & Gossett e-1510 1.5BC End Suction Pump

Before ordering, verify that your process-pumping system requires a 1.5BC casing with 2.5-inch suction and 1.5-inch discharge connections. You should select required flow and head through the applicable e-1510 curve, then confirm the 20 HP TEFC motor and 3525 RPM speed. Review environmental conditions, fluid requirements, pressure limits, piping support, and equipment-service clearance.