Bell & Gossett 1510 1-1/2 AC Custom Built Pump

Built for custom duty points, Bell & Gossett 1510 1-1/2 AC provides a base-mounted horizontal end-suction pump platform for primary HVAC loops and industrial fluid transfer. Its stainless steel investment-cast impeller, center drop-out coupling, and back pull-out design support applications where contractors need service access and pump configuration flexibility. Confirm the required GPM, head, motor selection, and suction conditions before ordering this custom-built pump.

The Bell & Gossett Series 1510 uses a 1-1/2 AC pump size with a horizontal end-suction layout and heavy-duty regreasable ball bearings. The center drop-out coupling supports maintenance access, while the back pull-out construction allows service planning around the rotating assembly. Verified data does not provide voltage, phase, horsepower, RPM, connection dimensions, seal material, operating temperature, dimensions, weight, thermal protection, or self-priming capability, so final configuration must follow the specified duty point.

Key Features of Bell & Gossett 1510 1-1/2 AC

- Custom-built centrifugal pump for specified GPM and head duty points.
- 1-1/2 AC pump size for primary HVAC and industrial fluid transfer.
- Base-mounted horizontal end-suction configuration supports fixed piping systems.
- Stainless steel investment-cast impeller supports corrosion-conscious circulation.
- Center drop-out coupling simplifies access during maintenance.
- Heavy-duty regreasable ball bearings support the pump shaft assembly.
- Back pull-out design supports service without removing the connected casing from the piping.
- Motor horsepower, voltage, phase, RPM, seal, temperature, dimensions, weight, and warranty terms require confirmation.

Why the Bell & Gossett 1510 1-1/2 AC Stands Out

This Bell & Gossett custom HVAC pump provides configuration flexibility for systems that require a specified operating point rather than a generic replacement selection.

- Build: Stainless steel impeller construction, regreasable ball bearings, and back pull-out architecture support service-oriented industrial pump installation.
- Value: Custom duty-point selection can reduce pump oversizing, hydraulic mismatch, energy waste, and premature component wear.
- Audience: HVAC engineers, pump contractors, industrial maintenance teams, boiler installers, and facility engineers can specify this model for custom circulation requirements.

Applications & Use Cases

Use the Bell & Gossett 1510 1-1/2 AC for primary HVAC loops, industrial fluid transfer, boiler circulation, and custom hydronic systems. Physical dimensions, unit weight, and suction or discharge port reach were not supplied, so confirm the base layout, pipe alignment, coupling clearance, bearing access, valve spacing, and lifting requirements before installation.

Warranty & Support

- Factory warranty terms were not included in the supplied specifications. Confirm warranty coverage, custom configuration requirements, motor selection, and authorized service support before purchase.
- Verify the duty point, prime the pump as required, grease the bearings according to the service schedule, and inspect the coupling and seal area during commissioning.

Check suction conditions, flush debris from the system, confirm shaft alignment, and monitor bearing and seal condition during scheduled service. Purchase the Bell & Gossett 1510 1-1/2 AC custom HVAC pump from [store domain] for authentic equipment, applicable factory warranty protection, and pump support.